Finding the push button on air conditioning could be difficult, especially when it’s done so rarely that it’s difficult to remember! Most of the AC units do not have a reset button but the Lennox AC unit provides you with one though it is not a separate switch. The pressure switch is the reset switch in this case. You’ll need to turn off the power and remove the rear panel, which is located on the liquid line (little copper line) at the bottom of the machine. It features a red rubber push switch that is pushed in. If something is wrong with your HVAC unit, look for air conditioner repair in San Jacinto, CA.
Why Do You Need To Reset The AC?
Power Outage
These power interruptions, whether blackouts or brownouts, may cause your unit to possess cooling issues until it’s reset. So you need to reset your AC unit. If resetting doesn’t work then you might need to call a pro. So, look for the AC Repair Service in Hemet, CA.
Thermostat Malfunctioning
It sometimes comes right down to a defective thermostat, regardless of what percentage of times you reset your air conditioning. It’s not tough work, and I’m sure one could finish it in an hour or two. But if it is still not working then you might need to call a professional. So, look for the air conditioner repair in San Jacinto, CA.
How To Reset The AC?
It’s really simple to reset an air conditioner using the reset button. Press and hold the reset button for 3 seconds before releasing it. Rep after about 10-15 seconds. Hold for 3 seconds before releasing. That’s all; your air conditioner has been reset.
Even if you do not have a reset button, you can make it work out in few more steps:
- Turn off the power. A shut-off panel is usually located near your unit’s compressor. Normally, this should be turned on all of the time. To reset the switch, turn it off and then turn off the main power panel inside.
Unplug the item from the power supply board as an extra precaution to ensure that it is not connected to any potential power sources. - It is recommended that you wait 30 minutes before reconnecting the power; you are not required to do so, but we recommend it. Waiting the extra time ensures that all of the electricity in your system has dissipated; if you don’t wait the extra time, you can wind up with the same problem as before.
- Before moving on to the following step, make sure your air conditioner is set to chill.
- Reconnect your air conditioner. Replace the main ac wire adjacent to the compressor and connect it to the power supply board outside. Turn on your primary home’s control panel once everything else has been connected back in.
Ease Of California is here to provide you with ease with the best professional AC services in Jacinto. You can contact us by calling us at (866) 788-3273.
